By Hamish Rodgers-Wilson, Australian Home Brewing, established 1968
This recipe makes about 20 litres of semi-sweet alcoholic ginger beer at roughly 4.5% strength. You can make it sweeter or drier, use a kit instead of fresh ginger, or make a low-alcohol soft drink version. Ginger beer is one of the most forgiving things you can brew: no hops, no long boil, and it is ready in a few weeks.
Three ways to make ginger beer at home
- From scratch with fresh ginger: the recipe below. Most control over the heat and sweetness.
- From a kit: the Buderim Ginger Beer Complete Brew Kit or Old Fashioned Ginger Beer. The quickest way to a reliable batch.
- Everything in one box: the AHB Ginger Beer Making Starter Kit has the fermenter, Buderim kit, dextrose, hydrometer, carbonation drops, capper and crown seals.
What you need
- A 30 litre fermenter with an airlock, such as the Fermenter 30L pail complete
- Enough bottles for 20 litres, with crown seals or screw caps
- Carbonation drops: 1 per 330 to 375 ml bottle, 2 per 650 to 750 ml bottle
- No-rinse sanitiser
- A straining bag
- A hydrometer (recommended)
Ingredients (20 litres)
- 2 kg dextrose (glucose)
- 500 g light dry malt extract
- 500 g lactose, for sweetness (optional, see below)
- 100 to 200 g fresh ginger, crushed or grated (vary to suit your taste)
- Up to 4 lemons, sliced or chopped fine including the peel (optional)
- 5 g yeast nutrient
- 1 sachet of SafAle ale yeast
- Water to make 22 litres
Method
- Heat 5 litres of water, add the dextrose, malt, lemons and ginger, and simmer for 20 minutes.
- Clean and sanitise your fermenter.
- Put about 12 litres of cold water in the fermenter. Pour the hot mixture through a straining bag into the fermenter.
- Top up with cold water to the 22 litre mark, add the yeast nutrient and stir well.
- Check the temperature is 30°C or less, then add the yeast. Fit the airlock and half fill it with water.
- Fermentation should start within 24 hours, and usually within a couple of hours. You will see bubbles rising through the ginger beer and through the airlock.
- Let it ferment until it stops. If you have a hydrometer, wait until the reading stays the same for one to two days.
- Let it settle and clear for 48 hours.
- Add carbonation drops to each bottle, fill to about 50 mm from the top and seal firmly.
- Store the bottles somewhere warm for one to two weeks to carbonate. They are then ready to drink.
Sweet or dry: why you sweeten with lactose, never sugar
You cannot sweeten a bottle-fermented drink with sugar or glucose. The yeast keeps eating it in the bottle, the pressure keeps building, and the bottles can explode. Lactose is a sugar the yeast cannot ferment, so it adds sweetness safely. It is about half as sweet as normal sugar. Use more or less to suit your taste, or leave it out for a dry ginger beer.
Make it from a kit instead
Old Fashioned Ginger Beer comes with a natural ginger emulsion, brewing yeast with nutrient, and stevia for sweetness, which you can dose to make it dry, mid-sweet or sweet. It makes 18 litres.
- Add 2 kg of dextrose for about 4.8% alcohol, or 1 kg for about 3%.
- Mix the ginger emulsion, yeast nutrient, stevia and dextrose with 4 litres of kettle-hot water in your fermenter. Do not add the yeast yet.
- Top up to the final volume with cold water and stir well. Add the yeast at around 25°C and brew between 18 and 24°C.
- For a dry ginger beer, reduce or leave out the stevia.
- For more ginger bite, soak 3 teaspoons of freshly grated ginger in half a cup of brandy for 3 hours, then strain it into the fermenter before you add the yeast.
Buderim Ginger Beer Complete Brew Kit is made with 80% real ginger syrup from Buderim on Queensland's Sunshine Coast. It makes 20 litres at about 4%, ferments in 5 to 10 days at 18 to 24°C, and carbonation drops are included. Keep it around 18 to 20°C for a crisper, drier finish.
Non-alcoholic ginger beer (the soft drink version)
To make a ginger beer soft drink, you only want the yeast to make enough gas to make it fizzy, not alcohol.
- Make up Old Fashioned Ginger Beer with 18 litres of water and no dextrose.
- Add carbonation drops to the bottles, then bottle and cap.
- Leave the bottles for about three weeks to carbonate and age.
- Once they are fizzy, move the bottles to the fridge and keep them there. The cold stops the yeast, so it cannot keep building pressure.
There will still be a little alcohol, usually about 0.5% or less. There will also be some yeast sediment in the bottom of each bottle. It is harmless and you can drink it, or pour carefully and leave it behind.
How to stop ginger beer bottles exploding
Exploding bottles are the classic home-made ginger beer story, and they always have the same cause: bottling before fermentation has finished, or adding fermentable sugar to sweeten it.
- Check it has finished. Take a hydrometer reading and wait until it stays the same for one to two days before bottling.
- Prime with carbonation drops, not a guess. They give the right amount of sugar for each bottle size.
- Sweeten with lactose or stevia only. Never sugar.
- Leave headspace. Fill to about 50 mm from the top.
- Plastic soft drink bottles help. You can feel the pressure building, so fill one alongside the rest as a check.
- Refrigerate soft drink batches once fizzy. They still have sugar the yeast can use if they stay warm.
Flavour ideas
- More heat: grated ginger soaked in brandy or port, strained in.
- Citrus: orange zest in the last day of fermentation.
- Herbal: lemongrass or mint near bottling time.
Adding flavours later in fermentation keeps more of the aroma.
Ginger beer vs ginger ale
| Ginger beer | Ginger ale |
|---|---|
| Fermented with yeast | Carbonated water with ginger flavour |
| Cloudy | Clear and golden |
| Bolder and spicier | Milder and sweeter |
| Contains some alcohol unless the fermentation is stopped | Non-alcoholic |
Frequently asked questions
Is ginger beer fermented?
Yes. Traditional ginger beer is fermented with yeast, which makes the gas that makes it fizzy and, if you let it, alcohol. Ginger ale is not fermented.
How strong is home-made alcoholic ginger beer?
This recipe makes about 4.5%. Old Fashioned Ginger Beer makes about 4.8% with 2 kg of dextrose or about 3% with 1 kg, and the Buderim kit makes about 4%.
Can I make non-alcoholic ginger beer at home?
Yes. Brew it without the dextrose, bottle with carbonation drops, then refrigerate once it is fizzy. It will still contain a trace of alcohol, usually about 0.5% or less.
How long does home-made ginger beer take?
The Buderim kit ferments in 5 to 10 days. Allow two more days to settle, then one to two weeks in the bottle to carbonate. The soft drink version needs about three weeks in the bottle.
Why is my ginger beer flat?
It may not have fermented long enough, or no carbonation drops went into the bottles. Keep the bottles somewhere warm for one to two weeks before you chill them.
Can I sweeten ginger beer with sugar?
Not in the bottle. The yeast will ferment it and the pressure can burst the bottles. Use lactose or stevia, which the yeast cannot ferment.
Do I need a special yeast?
A brewing yeast gives a cleaner, more reliable result than bread yeast. The kits include their own yeast; for the from-scratch recipe use a sachet of SafAle ale yeast.



Leave a comment
This site is protected by hCaptcha and the hCaptcha Privacy Policy and Terms of Service apply.